Basic
Premium
- Blower Motor- measure amperage and voltage for proper operation
- Check blower wheel for proper balance, clean blower wheel
- Thermostat – test for proper operation, check for proper location (replacements available for purchase)
- Check, Cleaning existing air filter (as needed) (replacements available for purchase)
- Check for proper draining – pan and drain line
- Bearings – inspect for wear
- Check and confirm proper return air and size
- Inspect condenser chassis and remove debris
- Wash outdoor condenser coils w/ lite chemical cleaner
- Refrigerant – check for proper charge and monitor operating pressures (refrigerant available for purchase)
- Safety Devices – inspect for proper operation
- Electrical Disconnect Box – inspect for proper rating and safe installation
- Electrical Wiring – inspect and tighten connections
- Test/inspect contactors for burned, pitted contacts
- Inspect electrical for exposed wiring
- Inspect and test capacitors (capacitors available for purchase)
- Inspect fan blade (clean if necessary)
- Inspect service valves for proper operation, check for locking caps (caps available for Purchase)
- Measure Supply/Return temperature differential
- Compressor – monitor, measure amperage and volt draw, check wiring connections
- Check unit for time delay relay
- Check condition of isolation pads/grommets (pads and grommets available for purchase)
- Inspect suction line for proper fittings
- Inspect all fittings for signs of oil and/or leakage
- Check the condition of Blower Belt, if applicable (belt available for purchase)
- Blower Motor- measure amperage and voltage for proper operation
- Check blower wheel for proper balance, clean blower wheel
- Thermostat – test for proper operation, calibrate, and level
- Cleaning existing air filter (as needed) (replacements available for purchase)
- Bearings – inspect for wear and lubricate(if necessary)
- Check for proper draining – drain pan and drain line, clean( if necessary) and treat with algae treatment
- Access, Inspect & chemical wash indoor evaporator coil
- Confirm proper return air and size
- Inspect condenser chassis and remove debris
- Wash outdoor condenser coils w/ heavy duty chemical cleaner
- Refrigerant – check for proper charge and monitor operating pressures (refrigerant available for purchase)
- Safety Devices – inspect for proper operation
- Electrical Disconnect Box – inspect for proper rating and safe installation
- Electrical Wiring – inspect and tighten connections
- Test/inspect contactors for burned, pitted contacts
- Inspect electrical for exposed wiring
- Inspect and test capacitors (capacitors available for purchase)
- Inspect fan blade (clean if necessary)
- Inspect service valves for proper operation,check for locking caps (caps available for Purchase)
- Measure Supply/Return temperature differential
- Measure for proper air flow volume
- Compressor – monitor, measure amperage and volt draw, check wiring connections
- Check unit for time delay relay
- Check condition of isolation pads/grommets (pads and grommets available for purchase)
- Inspect suction line for proper fittings
- Inspect all fittings for signs of oil and/or leakage
- Check the condition of Blower Belt, if applicable (belt available for purchase)
- Duct system – inspect for air leaks (air leak repair available for purchase)